MC10EP35DR2

MC10EP35DR2 Overview

In the form of 8-SOIC (0.154, 3.90mm Width), it has been packaged. You can find it in the Tape & Reel (TR)package. There is a Differentialoutput configured with it. There is a trigger configured with Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of -3V~-5.5Vis used as the supply voltage. -40°C~85°C TAis the operating temperature. Logic flip flops of this type are classified as JK Type. This type of FPGA is a part of the 10EP series. A frequency of 3GHzshould be the maximum output frequency. There have been 8 terminations. It is a member of the 10EP35 family. A voltage of 3.3V is used to power it. In terms of electronic devices, this device belongs to the 10Efamily of devices. There is an electronic component mounted in the way of Surface Mount. With its 8pins, it is designed to work with most electronic flip flops. This device has Positive Edgeas its clock edge trigger type. It is part of the FF/Latchesbase part number family. This flip flop is designed with 2 Bits. Vsup reaches 5.5V, the maximal supply voltage. The supply voltage (Vsup) should be kept above 3V for normal operation. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. The D latch runs on a voltage of -5.2V volts. The JK flip flop is with 1 output lines to operate. Furthermore, it has NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5Vas a characteristic. A high level output current of -50mAis set. A 50mAvalue is set for low-level output current.

MC10EP35DR2 Features

Tape & Reel (TR) package
10EP series
8 pins
2 Bits
-5.2V power supplies

MC10EP35DR2 Applications

There are a lot of ON Semiconductor MC10EP35DR2 Flip Flops applications.

• Count Modes
• Buffer registers
• ATE
• Differential Individual
• Frequency Dividers
• Single Up Count-Control Line
• Convert a momentary switch to a toggle switch
• Guaranteed simultaneous switching noise level
• Event Detectors
• Dynamic threshold performance