MC10EP451FAR2G

MC10EP451FAR2G Overview

As a result, it is packaged as 32-LQFP. There is an embedded version in the package Tape & Reel (TR). Currently, the output is configured to use Differential. The trigger configured with it uses Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of -3V~-5.5V volts. It is at -40°C~85°C TAdegrees Celsius that the system is operating. This D latch has the type D-Type. FPGAs belonging to the 10EPseries contain this type of chip. You should not exceed 3GHzin the output frequency of the device. A total of 1elements are contained within it. As a result, it consumes 125mA quiescent current. The 10EP451 family contains this object. This electronic part is mounted in the way of Surface Mount. 32pins are included in its design. The clock edge trigger type for this device is Positive Edge. The design is based on 6bits. Due to its superior flexibility, it uses 1 circuits. To operate, the chip has a total of 6 output lines. 6input lines are available for you to choose from. -50mAis set as the high level output current. Low level output current is set to 50mA. A temperature below 85°Cis recommended for operation. Ideally, the operating temperature should be higher than -40°C. The minimum voltage required for operation is 3V. In this case, it supports a maximum supply voltage of 5.5V. This frequency can be achieved at 3GHz.

MC10EP451FAR2G Features

Tape & Reel (TR) package
10EP series
32 pins
6 Bits

MC10EP451FAR2G Applications

There are a lot of ON Semiconductor MC10EP451FAR2G Flip Flops applications.

• QML qualified product
• Counters
• Count Modes
• Storage registers
• Convert a momentary switch to a toggle switch
• Buffered Clock
• Buffer registers
• Patented noise
• Memory
• ATE