MC74AC273N

MC74AC273N Overview

In the form of 20-DIP (0.300, 7.62mm), it has been packaged. As part of the package Tube, it is embedded. T flip flop uses Non-Invertedas its output configuration. The trigger it is configured with uses Positive Edge. Through Holemounts this electrical part. Powered by a 2V~6Vvolt supply, it operates as follows. Temperature is set to -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In this case, it is a type of FPGA belonging to the 74AC series. A frequency of 175MHzshould not be exceeded by its output. In total, it contains 1 elements. As a result, it consumes 8μA of quiescent current without being affected by external factors. The number of terminations is 20. Members of the 74AC273family make up this object. Power is provided by a 5V supply. Its input capacitance is 4.5pF farads. In terms of electronic devices, this device belongs to the ACfamily of devices. It is mounted in the way of Through Hole. As you can see from the design, it has pins with 20. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. It is included in FF/Latches. 8bits are used in its design. Vsup reaches 6V, the maximal supply voltage. Normally, the supply voltage (Vsup) should be above 2V. Its superior flexibility is attributed to its use of 8 circuits. Considering the reliability of this T flip flop, it is well suited for RAIL. It operates from 3.3/5V power supplies.

MC74AC273N Features

Tube package
74AC series
20 pins
8 Bits
3.3/5V power supplies

MC74AC273N Applications

There are a lot of ON Semiconductor MC74AC273N Flip Flops applications.

• Reduced system switching noise
• ESD performance
• ESD protection
• Guaranteed simultaneous switching noise level
• Divide a clock signal by 2 or 4
• Test & Measurement
• Control circuits
• Consumer
• QML qualified product
• Event Detectors