MC74ACT374DTR2G

MC74ACT374DTR2G Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). As part of the package Tape & Reel (TR), it is embedded. This output is configured with Tri-State, Non-Inverted. There is a trigger configured with Positive Edge. Surface Mountis in the way of this electric part. The JK flip flop operates at 4.5V~5.5Vvolts. It is operating at a temperature of -40°C~85°C TA. It belongs to the type D-Typeof flip flops. This type of FPGA is a part of the 74ACT series. There should be no greater frequency than 160MHzon its output. In total, there are 1 elements. This process consumes 8μA quiescents. Currently, there are 20 terminations. You can search similar parts based on 74ACT374. Power is supplied from a voltage of 5V volts. Input capacitance of this device is 4.5pF farads. This D flip flop belongs to the family of ACT. This electronic part is mounted in the way of Surface Mount. This board is designed with 20pins on it. A Positive Edgeclock edge trigger is used in this device. The part is included in FF/Latches. Flip flops designed with 8bits are used in this part. Its flexibility is enhanced by 8 circuits. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. A power supply of 5Vis required to operate it. The D flip flop has no ports embedded. In order to ensure high efficiency, the supply voltage should remain at 5V. It operates with 3 output lines.

MC74ACT374DTR2G Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
5V power supplies

MC74ACT374DTR2G Applications

There are a lot of ON Semiconductor MC74ACT374DTR2G Flip Flops applications.

• Frequency division
• Convert a momentary switch to a toggle switch
• Data Synchronizers
• Single Up Count-Control Line
• Reduced system switching noise
• Guaranteed simultaneous switching noise level
• Memory
• Frequency Divider circuits
• Circuit Design
• Latch-up performance