MC74HC174ADTR2G

MC74HC174ADTR2G Overview

The flip flop is packaged in 16-TSSOP (0.173, 4.40mm Width). Package Tape & Reel (TR)embeds it. This output is configured with Non-Inverted. This trigger uses the value Positive Edge. There is an electronic component mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 2V~6V volts. In the operating environment, the temperature is -55°C~125°C TA. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74HCseries FPGA. You should not exceed 35MHzin the output frequency of the device. A total of 1elements are present in it. As a result, it consumes 4μA quiescent current. There are 16 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. JK flip flop belongs to 74HC174 family. It is powered from a supply voltage of 5V. The input capacitance of this JK flip flopis 10pF farads. A device of this type belongs to the family of HC/UH. In this case, the electronic component is mounted in the way of Surface Mount. This board is designed with 16pins on it. This device exhibits a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. There are 6bits in this flip flop. There is a 6Vmaximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be above 2V. The superior flexibility is achieved through the use of 7 circuits. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. It is of 6 channels.

MC74HC174ADTR2G Features

Tape & Reel (TR) package
74HC series
16 pins
6 Bits

MC74HC174ADTR2G Applications

There are a lot of ON Semiconductor MC74HC174ADTR2G Flip Flops applications.

• Divide a clock signal by 2 or 4
• Control circuits
• Cold spare funcion
• Registers
• 2 – Bit synchronous counter
• EMI reduction circuitry
• Matched Rise and Fall
• ESCC
• Asynchronous counter
• Single Up Count-Control Line