MC74HC273AFEL

MC74HC273AFEL Overview

20-SOIC (0.209, 5.30mm Width)is the packaging method. The Tape & Reel (TR)package contains it. Non-Invertedis the output configured for it. JK flip flop uses Positive Edgeas the trigger. There is an electronic component mounted in the way of Surface Mount. A voltage of 2V~6Vis required for its operation. The operating temperature is -55°C~125°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of 74HCseries FPGA. You should not exceed 35MHzin its output frequency. In total, it contains 1 elements. During its operation, it consumes 4μA quiescent energy. A total of 20terminations have been recorded. It is a member of the 74HC273 family. A voltage of 3V is used to power it. The input capacitance of this T flip flop is 10pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Devices in the HC/UHfamily are electronic devices. The electronic part is mounted in the way of Surface Mount. It is designed with 20 pins. This device exhibits a clock edge trigger type of Positive Edge. The part is included in FF/Latches. There are 8bits in its design. It reaches 6Vwhen the supply voltage is maximal (Vsup). A normal operating voltage (Vsup) should remain above 2V. Its superior flexibility is attributed to its use of 8 circuits. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. A total of 2/6V power supplies are needed to run it.

MC74HC273AFEL Features

Tape & Reel (TR) package
74HC series
20 pins
8 Bits
2/6V power supplies

MC74HC273AFEL Applications

There are a lot of ON Semiconductor MC74HC273AFEL Flip Flops applications.

• Cold spare funcion
• QML qualified product
• Balanced 24 mA output drivers
• Single Up Count-Control Line
• Latch
• Patented noise
• Data transfer
• CMOS Process
• Communications
• ESCC