MC74HC374ANG

MC74HC374ANG Overview

20-DIP (0.300, 7.62mm)is the way it is packaged. There is an embedded version in the package Tube. The output it is configured with uses Tri-State, Non-Inverted. Positive Edgeis the trigger it is configured with. There is an electronic component mounted in the way of Through Hole. The JK flip flop operates at 2V~6Vvolts. It is at -55°C~125°C TAdegrees Celsius that the system is operating. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74HCseries FPGA. Its output frequency should not exceed 35MHz. The list contains 1 elements. Despite external influences, it consumes 4μAof quiescent current. The number of terminations is 20. You can search similar parts based on 74HC374. It is powered from a supply voltage of 3V. This T flip flop has a capacitance of 10pF farads at the input. In terms of electronic devices, this device belongs to the HC/UHfamily of devices. It is mounted by the way of Through Hole. Basically, it is designed with a set of 20 pins. This device has Positive Edgeas its clock edge trigger type. This device is part of the FF/Latchesbase part number family. There are 8bits in this flip flop. The maximal supply voltage (Vsup) reaches 6V. It is imperative that the supply voltage (Vsup) is maintained above 2Vin order to ensure normal operation. Despite its superior flexibility, it relies on 8 circuits to achieve it. There are 2/6V power supplies attached to it. This flip flop has a total of 2ports. With an output current of 7.8mA, it is possible to design the device in any way you want. There are 3 output lines in this JK flip flop.

MC74HC374ANG Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

MC74HC374ANG Applications

There are a lot of ON Semiconductor MC74HC374ANG Flip Flops applications.

• Frequency Dividers
• Communications
• ATE
• Consumer
• Latch-up performance
• Registers
• Load Control
• Frequency division
• Test & Measurement
• 2 – Bit synchronous counter