MC74HC377ADTG

MC74HC377ADTG Overview

The item is packaged in 20-TSSOP (0.173, 4.40mm Width)cases. D flip flop is embedded in the Tube package. The output it is configured with uses Non-Inverted. Positive Edgeis the trigger it is configured with. Surface Mountis positioned in the way of this electronic part. A 2V~6Vsupply voltage is required for it to operate. Temperature is set to -55°C~125°C TA. This logic flip flop is classified as type D-Type. In FPGA terms, D flip flop is a type of 74HCseries FPGA. A frequency of 35MHzshould not be exceeded by its output. D latch consists of 1 elements. As a result, it consumes 4μA of quiescent current without being affected by external factors. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. D latch belongs to the 74HC377 family. The D flip flop is powered by a voltage of 5V . Its input capacitance is 10pFfarads. It belongs to the family of electronic devices known as HC/UH. It is mounted by the way of Surface Mount. Basically, it is designed with a set of 20 pins. This device exhibits a clock edge trigger type of Positive Edge. This device is part of the FF/Latchesbase part number family. 8bits are used in its design. There is a 6Vmaximum supply voltage (Vsup). It is imperative that the supply voltage (Vsup) is maintained above 2Vin order to ensure normal operation. Considering the reliability of this T flip flop, it is well suited for RAIL. The system runs on a power supply of 2/6V watts. This input has 8lines.

MC74HC377ADTG Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

MC74HC377ADTG Applications

There are a lot of ON Semiconductor MC74HC377ADTG Flip Flops applications.

• Bus hold
• 2 – Bit synchronous counter
• Buffered Clock
• Memory
• Test & Measurement
• Storage Registers
• Instrumentation
• Clock pulse
• Automotive
• Frequency Dividers