MC74HC574ADWR2G

MC74HC574ADWR2G Overview

As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). D flip flop is included in the Tape & Reel (TR)package. As configured, the output uses Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. Surface Mountis occupied by this electronic component. The JK flip flop operates with an input voltage of 2V~6V volts. It is operating at -55°C~125°C TA. It is an electronic flip flop with the type D-Type. The FPGA belongs to the 74HC series. This D flip flop should not have a frequency greater than 35MHz. D latch consists of 1 elements. 20terminations have occurred. The 74HC574 family contains it. A voltage of 3V provides power to the D latch. Its input capacitance is 10pF farads. The electronic device belongs to the HC/UHfamily. There is an electronic part mounted in the way of Surface Mount. The 20pins are designed into the board. There is a clock edge trigger type of Positive Edgeon this device. This RS flip flops is a part number FF/Latches. There are 8bits in its design. There is a 6Vmaximum supply voltage (Vsup). Normal operation requires a supply voltage (Vsup) above 2V. On the basis of its reliable performance, this D flip flop is well suited for use with TAPE AND REEL. The D latch runs on a voltage of 2/6V volts. The flip flop has 2embedded ports. As a result of its output current of 7.8mA, it is very flexible in terms of design. To operate, the chip has a total of 3 output lines. This D latch consumes 4μA quiescent current at all. It is reported that there are 8 channels.

MC74HC574ADWR2G Features

Tape & Reel (TR) package
74HC series
20 pins
8 Bits
2/6V power supplies

MC74HC574ADWR2G Applications

There are a lot of ON Semiconductor MC74HC574ADWR2G Flip Flops applications.

• Circuit Design
• Data Synchronizers
• Cold spare funcion
• Storage Registers
• Differential Individual
• Safety Clamp
• Control circuits
• Buffer registers
• Computing
• Dynamic threshold performance