MC74LCX374DTR2

MC74LCX374DTR2 Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). Package Tape & Reel (TR)embeds it. It is configured with Tri-State, Non-Invertedas an output. The trigger configured with it uses Positive Edge. It is mounted in the way of Surface Mount. Powered by a 2V~3.6Vvolt supply, it operates as follows. The operating temperature is -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. In terms of FPGAs, it belongs to the 74LCX series. This D flip flop should not have a frequency greater than 150MHz. In total, it contains 1 elements. There is 10μA quiescent consumption. Terminations are 20. It is a member of the 74LCX16374 family. The power source is powered by 3.3V. There is 7pF input capacitance for this T flip flop. Electronic devices of this type belong to the LVC/LCX/Zfamily. There is an electronic part mounted in the way of Surface Mount. The 20pins are designed into the board. The clock edge trigger type for this device is Positive Edge. This RS flip flops is a part number FF/Latches. It is designed with a number of bits of 8. Normally, the supply voltage (Vsup) should be above 2V. In order to achieve its superior flexibility, 8 circuits are used. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. In order to achieve high efficiency, the supply voltage should be maintained at 3.3V. The JK flip flop is with 3 output lines to operate.

MC74LCX374DTR2 Features

Tape & Reel (TR) package
74LCX series
20 pins
8 Bits

MC74LCX374DTR2 Applications

There are a lot of ON Semiconductor MC74LCX374DTR2 Flip Flops applications.

• Frequency Divider circuits
• Dynamic threshold performance
• Memory
• Synchronous counter
• QML qualified product
• Reduced system switching noise
• CMOS Process
• Set-reset capability
• ATE
• Latch