MM74HC175MX

MM74HC175MX Overview

It is packaged in the way of 16-SOIC (0.154, 3.90mm Width). You can find it in the Tape & Reel (TR)package. Currently, the output is configured to use Differential. In the configuration of the trigger, Positive Edgeis used. Surface Mountis occupied by this electronic component. A voltage of 2V~6Vis used as the supply voltage. It is operating at -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. JK flip flop is a part of the 74HCseries of FPGAs. You should not exceed 70MHzin the output frequency of the device. D latch consists of 1 elements. It consumes 8μA of quiescent Terminations are 16. It is a member of the 74HC175 family. A JK flip flop with a 5pFfarad input capacitance is used here. In terms of electronic devices, this device belongs to the HC/UHfamily of devices. Surface Mount mounts this electronic component. The 16pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. This device is part of the FF/Latchesbase part number family. There are 4bits in its design. In this case, the maximum supply voltage (Vsup) reaches 6V. For normal operation, the supply voltage (Vsup) should be above 2V. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. It runs on 2/6Vvolts of power. 4is the number of channels.

MM74HC175MX Features

Tape & Reel (TR) package
74HC series
16 pins
4 Bits
2/6V power supplies

MM74HC175MX Applications

There are a lot of ON Semiconductor MM74HC175MX Flip Flops applications.

• Memory
• Shift Registers
• QML qualified product
• Data transfer
• Dynamic threshold performance
• Storage registers
• 2 – Bit synchronous counter
• Balanced Propagation Delays
• ESCC
• Circuit Design