MM74HC273WM

MM74HC273WM Overview

20-SOIC (0.295, 7.50mm Width)is the way it is packaged. It is contained within the Tubepackage. As configured, the output uses Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Surface Mountis in the way of this electric part. The JK flip flop operates with an input voltage of 2V~6V volts. The operating temperature is -40°C~85°C TA. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 74HC series. A frequency of 78MHzshould be the maximum output frequency. A total of 1elements are contained within it. A total of 20 terminations have been made. Members of the 74HC273family make up this object. It is powered from a supply voltage of 4.5V. The input capacitance of this JK flip flopis 7pF farads. In terms of electronic devices, this device belongs to the HC/UHfamily of devices. A part of the electronic system is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. A Positive Edgeclock edge trigger is used in this device. The part you are looking for is included in FF/Latches. The design is based on 8bits. It reaches the maximum supply voltage (Vsup) at 6V. Normal operation requires a supply voltage (Vsup) above 2V. There are 2/6V power supplies attached to it. As a result of its output current of 5.2mA, it is very flexible in terms of design. There are 8 output lines on it. It consumes 8μA of quiescent current without being affected by external factors. Currently, there are 8 channels available.

MM74HC273WM Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

MM74HC273WM Applications

There are a lot of ON Semiconductor MM74HC273WM Flip Flops applications.

• Latch-up performance
• Storage registers
• ESCC
• Reduced system switching noise
• 2 – Bit synchronous counter
• Asynchronous counter
• Frequency Dividers
• Synchronous counter
• Single Up Count-Control Line
• Load Control