MM74HC374WMX

MM74HC374WMX Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). It is contained within the Tape & Reel (TR)package. There is a Tri-State, Non-Invertedoutput configured with it. It is configured with a trigger that uses Positive Edge. There is an electric part mounted in the way of Surface Mount. It operates with a supply voltage of 2V~6V. The operating temperature is -40°C~85°C TA. The type of this D latch is D-Type. It is a type of FPGA belonging to the 74HC series. It should not exceed 35MHzin terms of its output frequency. D latch consists of 1 elements. 20terminations have occurred. D latch belongs to the 74HC374 family. Power is supplied from a voltage of 4.5V volts. This JK flip flop has a 5pFfarad input capacitance. In this case, the D flip flop belongs to the HC/UHfamily. Electronic part Surface Mountis mounted in the way. Basically, it is designed with a set of 20 pins. There is a clock edge trigger type of Positive Edgeon this device. It is included in FF/Latches. This flip flop is designed with 8 Bits. As soon as 6Vis reached, Vsup reaches its maximum value. The supply voltage (Vsup) should be kept above 2V for normal operation. Due to its reliability, this T flip flop is well suited for TR. It runs on 2/6Vvolts of power. The flip flop contains 2ports. There are 3 output lines in this JK flip flop. It consumes 8μA of quiescent current without being affected by external factors. There are 8 channels available.

MM74HC374WMX Features

Tape & Reel (TR) package
74HC series
20 pins
8 Bits
2/6V power supplies

MM74HC374WMX Applications

There are a lot of ON Semiconductor MM74HC374WMX Flip Flops applications.

• Event Detectors
• ESD performance
• Latch
• Storage registers
• Shift registers
• Memory
• Matched Rise and Fall
• Common Clocks
• Set-reset capability
• Frequency Divider circuits