MM74HCT273N

MM74HCT273N Overview

As a result, it is packaged as 20-DIP (0.300, 7.62mm). A package named Tubeincludes it. T flip flop is configured with an output of Non-Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electronic component mounted in the way of Through Hole. The JK flip flop operates at a voltage of 4.5V~5.5V. Temperature is set to -40°C~85°C TA. D-Typeis the type of this D latch. In terms of FPGAs, it belongs to the 74HCT series. Its output frequency should not exceed 68MHz. D latch consists of 1 elements. As a result, it consumes 8μA quiescent current. The number of terminations is 20. Power is supplied from a voltage of 5V volts. The input capacitance of this T flip flop is 6pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. In this case, the D flip flop belongs to the HCTfamily. As soon as 5.5Vis reached, Vsup reaches its maximum value. Normally, the supply voltage (Vsup) should be above 4.5V.

MM74HCT273N Features

Tube package
74HCT series

MM74HCT273N Applications

There are a lot of Rochester Electronics, LLC MM74HCT273N Flip Flops applications.

• Instrumentation
• Buffer registers
• Load Control
• Divide a clock signal by 2 or 4
• Circuit Design
• CMOS Process
• Frequency Divider circuits
• Matched Rise and Fall
• EMI reduction circuitry
• Data storage