MM74HCT574N

MM74HCT574N Overview

It is packaged in the way of 20-DIP (0.300, 7.62mm). Package Tubeembeds it. The output it is configured with uses Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. There is an electrical part that is mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis required for its operation. The operating temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. This type of FPGA is a part of the 74HCT series. A frequency of 33MHzshould not be exceeded by its output. D latch consists of 1 elements. This process consumes 8μA quiescents. The 74HCT574family includes it. The input capacitance of this T flip flop is 10pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. There is an electronic part that is mounted in the way of Through Hole. It is designed with 20 pins. It has a clock edge trigger type of Positive Edge. Using 8 circuits, it is highly flexible. If high efficiency is desired, the supply voltage should be kept at 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 7.2mA. It is designed with 3 output lines.

MM74HCT574N Features

Tube package
74HCT series
20 pins

MM74HCT574N Applications

There are a lot of ON Semiconductor MM74HCT574N Flip Flops applications.

• High Performance Logic for test systems
• Communications
• Bus hold
• Digital electronics systems
• Counters
• Computers
• Instrumentation
• Registers
• Parallel data storage
• Common Clocks