MM74HCT74MX

MM74HCT74MX Overview

14-SOIC (0.154, 3.90mm Width)is the way it is packaged. A package named Tape & Reel (TR)includes it. The output it is configured with uses Differential. It is configured with the trigger Positive Edge. There is an electric part mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. It is at -40°C~85°C TAdegrees Celsius that the system is operating. A flip flop of this type is classified as a D-Type. FPGAs belonging to the 74HCTseries contain this type of chip. Its output frequency should not exceed 27MHz Hz. As a result, it consumes 2μA quiescent current and is not affected by external forces. The number of terminations is 14. The 74HCT74 family contains this object. Power is provided by a 5V supply. The input capacitance of this JK flip flopis 5pF farads. Electronic devices of this type belong to the HCTfamily. A part of the electronic system is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 14. There is a clock edge trigger type of Positive Edgeon this device. The RS flip flops belongs to FF/Latches base part number. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. There are 5V power supplies attached to it. The supply voltage should be maintained at 5V for high efficiency. As a result of its output current of 4.8mA, it is very flexible in terms of design. There are 1 output lines in this JK flip flop. 2 channels are available.

MM74HCT74MX Features

Tape & Reel (TR) package
74HCT series
14 pins
5V power supplies

MM74HCT74MX Applications

There are a lot of ON Semiconductor MM74HCT74MX Flip Flops applications.

• Set-reset capability
• Guaranteed simultaneous switching noise level
• Circuit Design
• ESCC
• Counters
• 2 – Bit synchronous counter
• Storage registers
• Parallel data storage
• Bounce elimination switch
• Instrumentation