SN74ABT162823ADL

SN74ABT162823ADL Overview

It is packaged in the way of 56-BSSOP (0.295, 7.50mm Width). The package Tubecontains it. In the configuration, Tri-State, Non-Invertedis used as the output. The trigger it is configured with uses Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. A temperature of -40°C~85°C TAis used in the operation. The type of this D latch is D-Type. In this case, it is a type of FPGA belonging to the 74ABT series. There should be no greater frequency than 150MHzon its output. In total, it contains 2 elements. It consumes 500μA of quiescent In 56terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. D latch belongs to the 74ABT162823 family. A voltage of 5V is used as the power supply for this D latch. Its input capacitance is 3.5pFfarads. It belongs to the family of electronic devices known as ABT. This electronic part is mounted in the way of Surface Mount. There are 56pins on it. This device exhibits a clock edge trigger type of Positive Edge. The part you are looking for is included in FF/Latches. It is designed with 18bits. The power supply is 5V. The D flip flop has no ports embedded. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. This T flip flop features a maximum design flexibility due to its output current of 12mA. There are 3 output lines in this JK flip flop. As an additional reference, you may refer to electronic flip flop WITH CLEAR AND CLOCK ENABLE.

SN74ABT162823ADL Features

Tube package
74ABT series
56 pins
18 Bits
5V power supplies

SN74ABT162823ADL Applications

There are a lot of Texas Instruments SN74ABT162823ADL Flip Flops applications.

• Divide a clock signal by 2 or 4
• ESD protection
• Data storage
• Computers
• Bus hold
• Test & Measurement
• Computing
• Patented noise
• Storage registers
• Single Down Count-Control Line