SN74ABT16821DLR

SN74ABT16821DLR Overview

The item is packaged in 56-BSSOP (0.295, 7.50mm Width)cases. The package Cut Tape (CT)contains it. It is configured with Tri-State, Non-Invertedas an output. In the configuration of the trigger, Positive Edgeis used. In this case, the electronic component is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. A temperature of -40°C~85°C TAis used in the operation. This D latch has the type D-Type. JK flip flop belongs to the 74ABTseries of FPGAs. A frequency of 150MHzshould be the maximum output frequency. D latch consists of 2 elements. It consumes 500μA of quiescent current without being affected by external factors. There are 56 terminations,The 74ABT16821 family contains it. Power is supplied from a voltage of 5V volts. Input capacitance of this device is 3.5pF farads. In terms of electronic devices, this device belongs to the ABTfamily of devices. The electronic part is mounted in the way of Surface Mount. The 56pins are designed into the board. The clock edge trigger type for this device is Positive Edge. This RS flip flops is a part number FF/Latches. An electronic part with 20bits has been designed. This D flip flop is well suited for TR based on its reliable performance. The D latch operates on 5V volts. The flip flop has 2embedded ports. For high efficiency, the supply voltage should be kept at 5V. With an output current of 64mA, it is possible to design the device in any way you want. There are 10 output lines in this JK flip flop.

SN74ABT16821DLR Features

Cut Tape (CT) package
74ABT series
56 pins
20 Bits
5V power supplies

SN74ABT16821DLR Applications

There are a lot of Texas Instruments SN74ABT16821DLR Flip Flops applications.

• Computers
• Bounce elimination switch
• Latch-up performance
• Balanced Propagation Delays
• Data storage
• Divide a clock signal by 2 or 4
• Set-reset capability
• Guaranteed simultaneous switching noise level
• Supports Live Insertion
• Registers