SN74ABT534APWR

SN74ABT534APWR Overview

As a result, it is packaged as 20-TSSOP (0.173, 4.40mm Width). D flip flop is included in the Cut Tape (CT)package. T flip flop uses Tri-State, Invertedas its output configuration. In the configuration of the trigger, Positive Edgeis used. It is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. -40°C~85°C TAis the operating temperature. This logic flip flop is classified as type D-Type. JK flip flop belongs to the 74ABTseries of FPGAs. You should not exceed 175MHzin its output frequency. The element count is 1 . As a result, it consumes 250μA of quiescent current without being affected by external factors. There are 20 terminations,The 74ABT534 family contains this object. A voltage of 5V provides power to the D latch. The input capacitance of this JK flip flopis 3.5pF farads. It belongs to the family of electronic devices known as ABT. There is an electronic part that is mounted in the way of Surface Mount. 20pins are included in its design. This device's clock edge trigger type is Positive Edge. The part is included in FF/Latches. Flip flops designed with 8bits are used in this part. Due to its superior flexibility, it uses 8 circuits. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. A total of 5V power supplies are needed to run it. This D flip flop is equipped with 0 ports. For high efficiency, the supply voltage should be set to 5V. With an output current of 64mA, this device offers maximum design flexibility. It has 3 output lines to operate.

SN74ABT534APWR Features

Cut Tape (CT) package
74ABT series
20 pins
8 Bits
5V power supplies

SN74ABT534APWR Applications

There are a lot of Texas Instruments SN74ABT534APWR Flip Flops applications.

• High Performance Logic for test systems
• Registers
• Functionally equivalent to the MC10/100EL29
• Shift Registers
• Consumer
• Balanced 24 mA output drivers
• ESD performance
• Frequency division
• CMOS Process
• ATE