SN74ABT574ADWRE4

SN74ABT574ADWRE4 Overview

In the form of SOIC, it has been packaged. As part of the package Tape & Reel (TR), it is embedded. Currently, the output is configured to use TTL. In total, there are 1 elements. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. A voltage of 5V is used as the power supply for this D latch. An electronic device belonging to the family ABTcan be found here. It is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. A Positive Edgeclock edge trigger is used in this device. The part is included in FF/Latches. A reliable performance of this D flip flop makes it well suited for use in TR. A total of 5V power supplies are needed to run it. The D flip flop is embedded with 2ports. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. The JK flip flop is with 3 output lines to operate. -32mAis set as the high level output current. It is set to 64mAfor low level output current. The operating temperature should be lower than 85°C. Ideally, the operating temperature should be greater than -40°C. The minimal supply voltage is 4.5V. It supports the maximal supply voltage of 5.5V. This can be achieved at a frequency of 200MHz. BUS DRIVERis used as the logic IC in this D flip flop. It is equipped with 1 Functions . A total of 20 pins are present on this device. It offers maximum design flexibility with its output current of 64mA.

SN74ABT574ADWRE4 Features

Tape & Reel (TR) package
20 pins
5V power supplies
1 Functions
20 pin count

SN74ABT574ADWRE4 Applications

There are a lot of Texas Instruments SN74ABT574ADWRE4 Flip Flops applications.

• Communications
• Single Up Count-Control Line
• Convert a momentary switch to a toggle switch
• QML qualified product
• Divide a clock signal by 2 or 4
• Dynamic threshold performance
• Clock pulse
• Storage registers
• Individual Asynchronous Resets
• ATE