SN74ABT823DW

SN74ABT823DW Overview

In the form of 24-SOIC (0.295, 7.50mm Width), it has been packaged. Package Tubeembeds it. The output it is configured with uses Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis occupied by this electronic component. A voltage of 4.5V~5.5Vis used as the supply voltage. A temperature of -40°C~85°C TAis used in the operation. A flip flop of this type is classified as a D-Type. FPGAs belonging to the 74ABTseries contain this type of chip. It should not exceed 200MHzin terms of its output frequency. D latch consists of 1 elements. T flip flop consumes 250μA quiescent energy. The number of terminations is 24. JK flip flop belongs to 74ABT823 family. A voltage of 5V is used as the power supply for this D latch. There is 4pF input capacitance for this T flip flop. In this case, the D flip flop belongs to the ABTfamily. It is mounted in the way of Surface Mount. The 24pins are designed into the board. This device has Positive Edgeas its clock edge trigger type. This RS flip flops is a part number Bus Driver/Transceiver. It is designed with 9bits. The D latch runs on a voltage of 5V volts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. This T flip flop features a maximum design flexibility due to its output current of 64mA. To operate, the chip has a total of 3 output lines. Currently, there are 9 lines of input. There is also a characteristic of WITH CLEAR AND CLOCK ENABLE.

SN74ABT823DW Features

Tube package
74ABT series
24 pins
9 Bits
5V power supplies

SN74ABT823DW Applications

There are a lot of Texas Instruments SN74ABT823DW Flip Flops applications.

• High Performance Logic for test systems
• ESD protection
• 2 – Bit synchronous counter
• Set-reset capability
• Shift Registers
• Asynchronous counter
• Counters
• Supports Live Insertion
• Bus hold
• Memory