SN74ABT823NSR

SN74ABT823NSR Overview

As a result, it is packaged as 24-SOIC (0.209, 5.30mm Width). A package named Tape & Reel (TR)includes it. Currently, the output is configured to use Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. There is an electric part mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. The operating temperature is -40°C~85°C TA. D-Typedescribes this flip flop. In terms of FPGAs, it belongs to the 74ABT series. It should not exceed 200MHzin its output frequency. There are 1 elements in it. There is a consumption of 250μAof quiescent energy. There are 24 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The 74ABT823family includes it. A voltage of 5V is used as the power supply for this D latch. A 4pFfarad input capacitance is provided by this T flip flop. A device of this type belongs to the family of ABT. In this case, the electronic component is mounted in the way of Surface Mount. The 24pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. 9bits are used in its design. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. It runs on 5Vvolts of power. The D flip flop has no ports embedded. The supply voltage should be maintained at 5V for high efficiency. In order for the chip to function, it has 3output lines. A total of 9input lines have been provided. It is also characterized by WITH CLEAR AND CLOCK ENABLE.

SN74ABT823NSR Features

Tape & Reel (TR) package
74ABT series
24 pins
9 Bits
5V power supplies

SN74ABT823NSR Applications

There are a lot of Texas Instruments SN74ABT823NSR Flip Flops applications.

• Frequency division
• Bus hold
• Counters
• Computers
• Storage registers
• QML qualified product
• Count Modes
• Pattern generators
• EMI reduction circuitry
• Buffered Clock