SN74AC374N

SN74AC374N Overview

The flip flop is packaged in 20-DIP (0.300, 7.62mm). The package Tubecontains it. As configured, the output uses Tri-State, Non-Inverted. It is configured with the trigger Positive Edge. Through Holeis in the way of this electric part. A voltage of 2V~6Vis required for its operation. It is operating at -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In FPGA terms, D flip flop is a type of 74ACseries FPGA. This D flip flop should not have a frequency greater than 155MHz. A total of 1 elements are present. This process consumes 4μA quiescents. It has been determined that there have been 20 terminations. It is a member of the 74AC374 family. A voltage of 3.3V is used as the power supply for this D latch. JK flip flop input capacitance is 4.5pF farads. It is a member of the ACfamily of D flip flop. It is mounted in the way of Through Hole. This board has 20 pins. In this device, the clock edge trigger type is Positive Edge. This device has the base part number FF/Latches. An electronic part with 8bits has been designed. There is a 6Vmaximum supply voltage (Vsup). For normal operation, the supply voltage (Vsup) should be kept above 2V. 8 circuits are used to achieve its superior flexibility. The D flip flop has no ports embedded. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. A total of 3input lines have been provided.

SN74AC374N Features

Tube package
74AC series
20 pins
8 Bits

SN74AC374N Applications

There are a lot of Texas Instruments SN74AC374N Flip Flops applications.

• Cold spare funcion
• Reduced system switching noise
• Differential Individual
• Asynchronous counter
• Pattern generators
• Power down protection
• Common Clocks
• Bounce elimination switch
• Automotive
• CMOS Process