SN74AC74PWG4

SN74AC74PWG4 Overview

The item is packaged in TSSOPcases. In total, there are 2 elements. There have been 14 terminations. A voltage of 3V provides power to the D latch. Electronic devices of this type belong to the ACfamily. It is mounted in the way of Surface Mount. The 14pins are designed into the board. This device has the clock edge trigger type of Positive Edge. This part is included in FF/Latches. The flip flop is designed with 1bits. There are 3.3/5V power supplies attached to it. The number of input lines is 1. -24mAis the output current at high level. 24mAis set as the low level output current. It is recommended that the operating temperature be lower than 85°C. If the operating temperature is higher than -40°C, the system should operate properly. The minimal supply voltage is 2V. There is a maximum supply voltage of 6V. This can be achieved at a frequency of 160MHz. It adopts a logic IC of type D FLIP-FLOP. It is equipped with 2 functions . The D latch is equipped with 14 pins. It features maximum design flexibility due to the 24mA output current.

SN74AC74PWG4 Features

14 pins
1 Bits
3.3/5V power supplies
2 Functions
14 pin count

SN74AC74PWG4 Applications

There are a lot of Texas Instruments SN74AC74PWG4 Flip Flops applications.

• Safety Clamp
• Data storage
• Buffered Clock
• Matched Rise and Fall
• Functionally equivalent to the MC10/100EL29
• Event Detectors
• Individual Asynchronous Resets
• Single Up Count-Control Line
• Consumer
• Clock pulse