SN74AHC574DW

SN74AHC574DW Overview

It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). The Tubepackage contains it. T flip flop uses Tri-State, Non-Invertedas its output configuration. This trigger is configured to use Positive Edge. There is an electric part mounted in the way of Surface Mount. A 2V~5.5Vsupply voltage is required for it to operate. It is operating at -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. This type of FPGA is a part of the 74AHC series. Its output frequency should not exceed 115MHz. The element count is 1 . T flip flop consumes 4μA quiescent energy. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The 74AHC574family includes it. It is powered by a voltage of 3.3V . Its input capacitance is 3pF farads. The electronic device belongs to the AHC/VHC/H/U/Vfamily. Electronic part Surface Mountis mounted in the way. This board is designed with 20pins on it. This device's clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. It is designed with 8bits. It reaches the maximum supply voltage (Vsup) at 5.5V. Normally, the supply voltage (Vsup) should be kept above 2V. Despite its superior flexibility, it relies on 8 circuits to achieve it. The system runs on a power supply of 2/5.5V watts. The D flip flop is embedded with 2ports. Its output current of 8mAallows for maximum design flexibility. As of now, there are 3input lines.

SN74AHC574DW Features

Tube package
74AHC series
20 pins
8 Bits
2/5.5V power supplies

SN74AHC574DW Applications

There are a lot of Texas Instruments SN74AHC574DW Flip Flops applications.

• Test & Measurement
• ESD protection
• CMOS Process
• Data transfer
• Buffer registers
• Safety Clamp
• Instrumentation
• Cold spare funcion
• Differential Individual
• Pattern generators