SN74AHCT174DBR

SN74AHCT174DBR Overview

The flip flop is packaged in 16-SSOP (0.209, 5.30mm Width). There is an embedded version in the package Cut Tape (CT). In the configuration, Non-Invertedis used as the output. This trigger is configured to use Positive Edge. This electronic part is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. -40°C~85°C TAis the operating temperature. Logic flip flops of this type are classified as D-Type. This type of FPGA is a part of the 74AHCT series. You should not exceed 115MHzin its output frequency. In total, it contains 1 elements. It consumes 4μA of quiescent current without being affected by external factors. Currently, there are 16 terminations. The 74AHCT174family includes it. The power source is powered by 5V. This JK flip flop has a 2pFfarad input capacitance. Devices in the AHCT/VHCT/VTfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. With its 16pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. The RS flip flops belongs to FF/Latches base part number. To achieve this superior flexibility, 7 circuits are used. Considering the reliability of this T flip flop, it is well suited for TR. The system runs on a power supply of 5V watts. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. Currently, there are 3 lines of input.

SN74AHCT174DBR Features

Cut Tape (CT) package
74AHCT series
16 pins
5V power supplies

SN74AHCT174DBR Applications

There are a lot of Texas Instruments SN74AHCT174DBR Flip Flops applications.

• Divide a clock signal by 2 or 4
• Counters
• Latch
• Memory
• Common Clocks
• Test & Measurement
• Control circuits
• QML qualified product
• Computing
• Data Synchronizers