SN74AHCT174DGVR

SN74AHCT174DGVR Overview

As a result, it is packaged as 16-TFSOP (0.173, 4.40mm Width). The package Tape & Reel (TR)contains it. The output it is configured with uses Non-Inverted. This trigger uses the value Positive Edge. The electronic part is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. It is operating at a temperature of -40°C~85°C TA. This electronic flip flop is of type D-Type. In FPGA terms, D flip flop is a type of 74AHCTseries FPGA. You should not exceed 115MHzin the output frequency of the device. In total, it contains 1 elements. There is 4μA quiescent consumption. 16terminations have occurred. It is a member of the 74AHCT174 family. A voltage of 5V is used to power it. Its input capacitance is 2pF farads. An electronic device belonging to the family AHCT/VHCT/VTcan be found here. A part of the electronic system is mounted in the way of Surface Mount. The 16pins are designed into the board. This device has the clock edge trigger type of Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. Vsup reaches 5.5V, the maximal supply voltage. For normal operation, the supply voltage (Vsup) should be above 4.5V. Its superior flexibility is attributed to its use of 7 circuits. On the basis of its reliable performance, this D flip flop is well suited for use with TAPE AND REEL. The D latch runs on a voltage of 5V volts. Currently, there are 3 input lines present.

SN74AHCT174DGVR Features

Tape & Reel (TR) package
74AHCT series
16 pins
5V power supplies

SN74AHCT174DGVR Applications

There are a lot of Texas Instruments SN74AHCT174DGVR Flip Flops applications.

• Asynchronous counter
• Safety Clamp
• Data transfer
• Balanced 24 mA output drivers
• Latch
• Bounce elimination switch
• Divide a clock signal by 2 or 4
• Functionally equivalent to the MC10/100EL29
• Reduced system switching noise
• Synchronous counter