SN74AHCT374PWR

SN74AHCT374PWR Overview

In the form of 20-TSSOP (0.173, 4.40mm Width), it has been packaged. D flip flop is included in the Cut Tape (CT)package. The output it is configured with uses Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Surface Mountis occupied by this electronic component. A voltage of 4.5V~5.5Vis used as the supply voltage. -40°C~85°C TAis the operating temperature. It belongs to the type D-Typeof flip flops. FPGAs belonging to the 74AHCTseries contain this type of chip. Its output frequency should not exceed 130MHz Hz. In total, it contains 1 elements. A total of 20 terminations have been made. The 74AHCT374family includes it. The D flip flop is powered by a voltage of 5V . A JK flip flop with a 4pFfarad input capacitance is used here. The electronic device belongs to the AHCT/VHCT/VTfamily. There is an electronic component mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. This device exhibits a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. Flip flops designed with 8bits are used in this part. Despite its superior flexibility, it relies on 8 circuits to achieve it. In light of its reliable performance, this T flip flop is well suited for TR. It operates from 5V power supplies. The D flip flop has no ports embedded. Optimal efficiency requires a supply voltage of 5V. A total of 3input lines have been provided. It consumes 4μA of quiescent current without being affected by external factors.

SN74AHCT374PWR Features

Cut Tape (CT) package
74AHCT series
20 pins
8 Bits
5V power supplies

SN74AHCT374PWR Applications

There are a lot of Texas Instruments SN74AHCT374PWR Flip Flops applications.

• Data storage
• ATE
• Bounce elimination switch
• Counters
• Matched Rise and Fall
• Shift registers
• Computers
• Synchronous counter
• Data transfer
• Pattern generators