SN74AHCT74QDRG4Q1

SN74AHCT74QDRG4Q1 Overview

The package is in the form of 14-SOIC (0.154, 3.90mm Width). As part of the package Tape & Reel (TR), it is embedded. T flip flop is configured with an output of Differential. It is configured with a trigger that uses a value of Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. It is operating at a temperature of -40°C~125°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of Automotive, AEC-Q100, 74AHCTseries FPGA. Its output frequency should not exceed 140MHz. As a result, it consumes 2μA quiescent current. There have been 14 terminations. If you search by 74AHCT74, you will find similar parts. The D flip flop is powered by a voltage of 5V . The input capacitance of this T flip flop is 2pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. This D flip flop belongs to the family of AHCT/VHCT/VT. In this case, the electronic component is mounted in the way of Surface Mount. As you can see from the design, it has pins with 14. In this device, the clock edge trigger type is Positive Edge. The part is included in FF/Latches. In order to achieve its superior flexibility, 2 circuits are used. Considering its reliability, this T flip flop is well suited for TR. A power supply of 5Vis required to operate it. In order to ensure high efficiency, the supply voltage should remain at 5V. There are 1 output lines in this JK flip flop.

SN74AHCT74QDRG4Q1 Features

Tape & Reel (TR) package
Automotive, AEC-Q100, 74AHCT series
14 pins
5V power supplies

SN74AHCT74QDRG4Q1 Applications

There are a lot of Texas Instruments SN74AHCT74QDRG4Q1 Flip Flops applications.

• Supports Live Insertion
• Patented noise
• Power down protection
• Computers
• ATE
• Differential Individual
• Pattern generators
• Parallel data storage
• Storage registers
• Modulo – n – counter