SN74ALS109AD

SN74ALS109AD Overview

In the form of 16-SOIC (0.154, 3.90mm Width), it has been packaged. D flip flop is embedded in the Tube package. There is a Differentialoutput configured with it. This trigger is configured to use Positive Edge. Surface Mountis occupied by this electronic component. A voltage of 4.5V~5.5Vis used as the supply voltage. In this case, the operating temperature is 0°C~70°C TA. The type of this D latch is JK Type. In FPGA terms, D flip flop is a type of 74ALSseries FPGA. There should be no greater frequency than 34MHzon its output. As a result, it consumes 4mA of quiescent current without being affected by external factors. There are 16 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. You can search similar parts based on 74ALS109. It is powered by a voltage of 5V . It is a member of the ALSfamily of D flip flop. Electronic part Surface Mountis mounted in the way. This board is designed with 16pins on it. This device exhibits a clock edge trigger type of Positive Edge. This device has the base part number FF/Latches. 2 circuits are used to achieve its superior flexibility. The D latch runs on a voltage of 5V volts. For high efficiency, the supply voltage should be set to 5V. With an output current of 8mA, this device offers maximum design flexibility. It has 5lines.

SN74ALS109AD Features

Tube package
74ALS series
16 pins
5V power supplies

SN74ALS109AD Applications

There are a lot of Texas Instruments SN74ALS109AD Flip Flops applications.

• Balanced 24 mA output drivers
• Power down protection
• Safety Clamp
• Count Modes
• Memory
• Frequency Dividers
• Load Control
• High Performance Logic for test systems
• Shift registers
• Functionally equivalent to the MC10/100EL29