SN74ALS174D

SN74ALS174D Overview

The flip flop is packaged in 16-SOIC (0.154, 3.90mm Width). There is an embedded version in the package Tube. Currently, the output is configured to use Non-Inverted. The trigger configured with it uses Positive Edge. The electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. Temperature is set to 0°C~70°C TA. This logic flip flop is classified as type D-Type. It is a type of FPGA belonging to the 74ALS series. There should be no greater frequency than 50MHzon its output. D latch consists of 1 elements. There is a consumption of 19mAof quiescent energy. A total of 16terminations have been recorded. The 74ALS174 family contains it. Power is supplied from a voltage of 5V volts. An electronic device belonging to the family ALScan be found here. Electronic part Surface Mountis mounted in the way. With its 16pins, it is designed to work with most electronic flip flops. This device's clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. To achieve this superior flexibility, 7 circuits are used. A power supply of 5Vis required to operate it. In order to achieve high efficiency, the supply voltage should be maintained at 5V. With an output current of 8mA, it is possible to design the device in any way you want. It is designed with 2 output lines. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply.

SN74ALS174D Features

Tube package
74ALS series
16 pins
5V power supplies

SN74ALS174D Applications

There are a lot of Texas Instruments SN74ALS174D Flip Flops applications.

• Balanced 24 mA output drivers
• Memory
• Buffer registers
• Control circuits
• CMOS Process
• Registers
• Differential Individual
• Frequency Dividers
• Computers
• Safety Clamp