SN74ALS577ADW

SN74ALS577ADW Overview

It is packaged in the way of 24-SOIC (0.295, 7.50mm Width). The package Tubecontains it. T flip flop uses Tri-State, Invertedas the output. JK flip flop uses Positive Edgeas the trigger. There is an electric part mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. 0°C~70°C TAis the operating temperature. This logic flip flop is classified as type D-Type. It is a type of FPGA belonging to the 74ALS series. This D flip flop should not have a frequency greater than 30MHz. In total, it contains 1 elements. Despite external influences, it consumes 18mAof quiescent current. In 24terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. Members of the 74ALS577family make up this object. It is powered by a voltage of 5V . The electronic device belongs to the ALSfamily. There is an electronic component mounted in the way of Surface Mount. With its 24pins, it is designed to work with most electronic flip flops. It has a clock edge trigger type of Positive Edge. The part is included in FF/Latches. 8bits are used in its design. In order to achieve its superior flexibility, 8 circuits are used. The D latch runs on a voltage of 5V volts. The D flip flop has no ports embedded. For high efficiency, the supply voltage should be set to 5V. With an output current of 24mA, it is possible to design the device in any way you want. It has 4lines.

SN74ALS577ADW Features

Tube package
74ALS series
24 pins
8 Bits
5V power supplies

SN74ALS577ADW Applications

There are a lot of Texas Instruments SN74ALS577ADW Flip Flops applications.

• Automotive
• Data Synchronizers
• Frequency Dividers
• Load Control
• Set-reset capability
• 2 – Bit synchronous counter
• Frequency division
• Individual Asynchronous Resets
• Storage Registers
• Control circuits