SN74ALS873BNT

SN74ALS873BNT Overview

In the package 24-DIP (0.300, 7.62mm), it can be found. The package is in the form of Tube. Tri-State is used for the output it is configured with. There is D-Type Transparent Latch logic type for this electrical device. Based on the way of Through Hole, this electronic part is mounted. A 4.5V~5.5V supply voltage is required to operate it. It is 0°C~70°C at the operating temperature. It is a type of FPGA belonging to the 74ALS series. 4 Bits are used in the design of this electronic part. There are 24 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The family in which it belongs to is 74ALS873. With a supply voltage of 5V, it operates. 24 pins are included. There is a device in this electronic family called ALS. There are 24 pins on it. The electronic part is mounted using the Through Hole method. This device has 2 ports on board, which are all available at the same time. This part can be found within the Bus Driver/Transceiver subcategory. There are 5V power supplies attached to it. There are 8 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. As the output current is 24mA, the design flexibility is maximum. High efficiency requires maintaining the supply voltage at 5V. There is also WITH CLEAR characteristics to it.

SN74ALS873BNT Features

24-DIP (0.300, 7.62mm) package
74ALS series
4 Bits
74ALS873 family
24 pin count
24 pins
5V power supplies

SN74ALS873BNT Applications

There are a lot of Texas Instruments SN74ALS873BNT Latches applications.

• Automotive HEV/EV Powertrain
• Decade counting 7-segment decimal display
• Bus system register with enable parallel lines at bus side
• Automatic test equipment
• Display driver
• Automotive Body Electronics
• Parallel data storage
• Four-bit storage with output enable
• Shift right with parallel loading
• Stacked or Push-Down Registers