SN74ALS876ADWRE4

SN74ALS876ADWRE4 Overview

The flip flop is packaged in 24-SOIC (0.295, 7.50mm Width). There is an embedded version in the package Tape & Reel (TR). Tri-State, Invertedis the output configured for it. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. It is operating at 0°C~70°C TA. It belongs to the type D-Typeof flip flops. JK flip flop belongs to the 74ALSseries of FPGAs. Its output frequency should not exceed 30MHz Hz. In total, it contains 2 elements. It consumes 21mA of quiescent current without being affected by external factors. In 24terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The 74ALS876family includes it. The power source is powered by 5V. An electronic device belonging to the family ALScan be found here. There is an electronic part that is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 24. There is a clock edge trigger type of Positive Edgeon this device. This RS flip flops is a part number FF/Latches. Vsup reaches 5.5V, the maximal supply voltage. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. The D latch operates on 5V volts. This D flip flop is equipped with 0 ports. It offers maximum design flexibility with its output current of 24mA. There are 1 output lines on it. Additionally, it is characterized by WITH PRESET.

SN74ALS876ADWRE4 Features

Tape & Reel (TR) package
74ALS series
24 pins
5V power supplies

SN74ALS876ADWRE4 Applications

There are a lot of Texas Instruments SN74ALS876ADWRE4 Flip Flops applications.

• Bounce elimination switch
• Asynchronous counter
• ESD protection
• Memory
• Computers
• Dynamic threshold performance
• Bus hold
• Parallel data storage
• Single Up Count-Control Line
• Matched Rise and Fall