SN74AS175BDR

SN74AS175BDR Overview

The package is in the form of 16-SOIC (0.154, 3.90mm Width). You can find it in the Tape & Reel (TR)package. The output it is configured with uses Differential. The trigger it is configured with uses Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 4.5V~5.5V. The operating temperature is 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. JK flip flop is a part of the 74ASseries of FPGAs. Its output frequency should not exceed 100MHz Hz. In total, it contains 1 elements. It consumes 34mA of quiescent current without being affected by external factors. Currently, there are 16 terminations. The 74AS175 family contains it. A voltage of 5V is used to power it. In this case, the D flip flop belongs to the ASfamily. A part of the electronic system is mounted in the way of Surface Mount. This board has 16 pins. A Positive Edgeclock edge trigger is used in this device. This device has the base part number FF/Latches. Using 7 circuits, it is highly flexible. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. A power supply of 5Vis required to operate it. For high efficiency, the supply voltage should be kept at 5V. The 20mA output current allows it to be designed with the greatest amount of flexibility. It is designed with 2 output lines. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply.

SN74AS175BDR Features

Tape & Reel (TR) package
74AS series
16 pins
5V power supplies

SN74AS175BDR Applications

There are a lot of Texas Instruments SN74AS175BDR Flip Flops applications.

• Balanced 24 mA output drivers
• Storage Registers
• Reduced system switching noise
• Bounce elimination switch
• Computing
• High Performance Logic for test systems
• Modulo – n – counter
• Convert a momentary switch to a toggle switch
• 2 – Bit synchronous counter
• Load Control