SN74AS4374BDWRG4

SN74AS4374BDWRG4 Overview

The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. You can find it in the Tape & Reel (TR)package. As configured, the output uses Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. There is an electric part mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. A temperature of 0°C~70°C TAis considered to be the operating temperature. This D latch has the type D-Type. The 74ASseries comprises this type of FPGA. Its output frequency should not exceed 125MHz. The element count is 1 . This process consumes 150mA quiescents. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. JK flip flop belongs to 74AS4374 family. Power is supplied from a voltage of 5V volts. The electronic device belongs to the ASfamily. This electronic part is mounted in the way of Surface Mount. The 20pins are designed into the board. It has a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. The flip flop is designed with 8bits. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. There are 5V power supplies attached to it. A total of 2ports are embedded in the D flip flop. If high efficiency is desired, the supply voltage should be kept at 5V. Featuring the maximum design flexibility, it has an output current of 48mA . A total of 8input lines have been provided. Additionally, there are DUAL-RANK FLIP-FLOP on the electronic flip flop that can be referred to.

SN74AS4374BDWRG4 Features

Tape & Reel (TR) package
74AS series
20 pins
8 Bits
5V power supplies

SN74AS4374BDWRG4 Applications

There are a lot of Texas Instruments SN74AS4374BDWRG4 Flip Flops applications.

• Reduced system switching noise
• Cold spare funcion
• ATE
• Divide a clock signal by 2 or 4
• Bus hold
• Asynchronous counter
• Computing
• Registers
• Latch-up performance
• Common Clocks