SN74AS574DW

SN74AS574DW Overview

The package is in the form of 20-SOIC (0.295, 7.50mm Width). As part of the package Tube, it is embedded. There is a Tri-State, Non-Invertedoutput configured with it. It is configured with a trigger that uses a value of Positive Edge. This electronic part is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. In the operating environment, the temperature is 0°C~70°C TA. A flip flop of this type is classified as a D-Type. JK flip flop belongs to the 74ASseries of FPGAs. In order for it to function properly, its output frequency should not exceed 90MHz. A total of 1 elements are present. During its operation, it consumes 116mA quiescent energy. There are 20 terminations,D latch belongs to the 74AS574 family. A voltage of 5V provides power to the D latch. In terms of electronic devices, this device belongs to the ASfamily of devices. There is an electronic component mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. It has a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. An electronic part with 8bits has been designed. The superior flexibility of this product is achieved by using 8 circuits. An electrical current of 5V volts is applied to it. The D flip flop is embedded with 2ports. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. Its output current of 48mAallows for maximum design flexibility. Currently, there are 3 input lines present.

SN74AS574DW Features

Tube package
74AS series
20 pins
8 Bits
5V power supplies

SN74AS574DW Applications

There are a lot of Texas Instruments SN74AS574DW Flip Flops applications.

• QML qualified product
• Consumer
• Bounce elimination switch
• Clock pulse
• Safety Clamp
• Memory
• Latch-up performance
• Data Synchronizers
• Common Clocks
• Load Control