SN74AS576DW

SN74AS576DW Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. D flip flop is embedded in the Tube package. T flip flop uses Tri-State, Invertedas the output. In the configuration of the trigger, Positive Edgeis used. In this case, the electronic component is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. In the operating environment, the temperature is 0°C~70°C TA. Logic flip flops of this type are classified as D-Type. The FPGA belongs to the 74AS series. You should not exceed 125MHzin the output frequency of the device. In total, it contains 1 elements. It consumes 125mA of quiescent There have been 20 terminations. Members of the 74AS576family make up this object. It is powered from a supply voltage of 5V. Devices in the ASfamily are electronic devices. There is an electronic part mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. The clock edge trigger type for this device is Positive Edge. It is part of the FF/Latchesbase part number family. It is designed with 8bits. The superior flexibility of this circuit is achieved by using 8 circuits. An electrical current of 5V volts is applied to it. This D flip flop is equipped with 0 ports. In order to ensure high efficiency, the supply voltage should remain at 5V. With a current output of 48mA , it offers maximum design flexibility. Currently, there are 3 lines of input.

SN74AS576DW Features

Tube package
74AS series
20 pins
8 Bits
5V power supplies

SN74AS576DW Applications

There are a lot of Texas Instruments SN74AS576DW Flip Flops applications.

• Registers
• Single Down Count-Control Line
• Data Synchronizers
• Convert a momentary switch to a toggle switch
• Event Detectors
• Patented noise
• Synchronous counter
• Load Control
• Buffer registers
• Modulo – n – counter