SN74AS576N

SN74AS576N Overview

It is packaged in the way of 20-DIP (0.300, 7.62mm). It is included in the package Tube. T flip flop uses Tri-State, Invertedas the output. It is configured with a trigger that uses Positive Edge. The electronic part is mounted in the way of Through Hole. A 4.5V~5.5Vsupply voltage is required for it to operate. In this case, the operating temperature is 0°C~70°C TA. This logic flip flop is classified as type D-Type. This type of FPGA is a part of the 74AS series. A frequency of 125MHzshould not be exceeded by its output. A total of 1elements are present in it. This process consumes 125mA quiescents. It has been determined that there have been 20 terminations. JK flip flop belongs to 74AS576 family. A voltage of 5V is used as the power supply for this D latch. It belongs to the family of electronic devices known as AS. This electronic part is mounted in the way of Through Hole. This board is designed with 20pins on it. Its clock edge trigger type is Positive Edge. It is part of the FF/Latchesbase part number family. An electronic part designed with 8bits is used in this application. Its superior flexibility is attributed to its use of 8 circuits. There are 5V power supplies attached to it. There are 2 ports embedded in the flip flops. Optimal efficiency requires a supply voltage of 5V. This T flip flop features a maximum design flexibility due to its output current of 48mA. As of now, there are 3input lines.

SN74AS576N Features

Tube package
74AS series
20 pins
8 Bits
5V power supplies

SN74AS576N Applications

There are a lot of Texas Instruments SN74AS576N Flip Flops applications.

• Divide a clock signal by 2 or 4
• Dynamic threshold performance
• Guaranteed simultaneous switching noise level
• Safety Clamp
• Consumer
• Memory
• Event Detectors
• Registers
• Shift registers
• Functionally equivalent to the MC10/100EL29