SN74AS825ADW

SN74AS825ADW Overview

The flip flop is packaged in 24-SOIC (0.295, 7.50mm Width). D flip flop is included in the Tubepackage. There is a Tri-State, Non-Invertedoutput configured with it. The trigger it is configured with uses Positive Edge. Surface Mountis in the way of this electric part. It operates with a supply voltage of 4.5V~5.5V. In this case, the operating temperature is 0°C~70°C TA. It belongs to the type D-Typeof flip flops. It is a type of FPGA belonging to the 74AS series. There are 1 elements in it. As a result, it consumes 73mA quiescent current and is not affected by external forces. A total of 24terminations have been recorded. This D latch belongs to the family of 74AS825. Power is provided by a 5V supply. Devices in the ASfamily are electronic devices. There is an electronic component mounted in the way of Surface Mount. 24pins are included in its design. This device has the clock edge trigger type of Positive Edge. The RS flip flops belongs to FF/Latches base part number. A total of 5V power supplies are needed to run it. The flip flop has 2ports embedded within it. For high efficiency, the supply voltage should be set to 5V. With an output current of 48mA, this device offers maximum design flexibility. There are 5 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. In addition, WITH TRIPLE OUTPUT ENABLE; WITH CLEAR AND CLOCK ENABLEis a characteristic of it. It is possible to obtain a frequency of 1MHz.

SN74AS825ADW Features

Tube package
74AS series
24 pins
5V power supplies

SN74AS825ADW Applications

There are a lot of Texas Instruments SN74AS825ADW Flip Flops applications.

• Frequency Divider circuits
• Data Synchronizers
• Reduced system switching noise
• Convert a momentary switch to a toggle switch
• Single Down Count-Control Line
• High Performance Logic for test systems
• Instrumentation
• Buffered Clock
• Parallel data storage
• Power down protection