SN74AVC16374DGGR

SN74AVC16374DGGR Overview

The flip flop is packaged in 48-TFSOP (0.240, 6.10mm Width). As part of the package Cut Tape (CT), it is embedded. There is a Tri-State, Non-Invertedoutput configured with it. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The supply voltage is set to 1.4V~3.6V. Currently, the operating temperature is -40°C~85°C TA. It belongs to the type D-Typeof flip flops. JK flip flop is a part of the 74AVCseries of FPGAs. Its output frequency should not exceed 200MHz. The element count is 2 . Despite external influences, it consumes 40μAof quiescent current. Terminations are 48. This D latch belongs to the family of 74AVC16374. It is powered by a voltage of 1.5V . Input capacitance of this device is 3pF farads. In this case, the D flip flop belongs to the AVCfamily. There is an electronic part mounted in the way of Surface Mount. With its 48pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This RS flip flops is a part number FF/Latches. This flip flop is designed with 16 Bits. A reliable performance of this D flip flop makes it well suited for use in TR. The flip flop has 2embedded ports. Its output current of 12mAallows for maximum design flexibility. To operate, the chip has a total of 1 output lines. The number of input lines is 3.

SN74AVC16374DGGR Features

Cut Tape (CT) package
74AVC series
48 pins
16 Bits

SN74AVC16374DGGR Applications

There are a lot of Texas Instruments SN74AVC16374DGGR Flip Flops applications.

• ATE
• Modulo – n – counter
• Differential Individual
• Memory
• Power down protection
• Control circuits
• Count Modes
• Buffer registers
• Memory
• Asynchronous counter