SN74F112NSR

SN74F112NSR Overview

In the form of 16-SOIC (0.209, 5.30mm Width), it has been packaged. The Tape & Reel (TR)package contains it. There is a Differentialoutput configured with it. This trigger uses the value Negative Edge. Surface Mountis in the way of this electric part. The supply voltage is set to 4.5V~5.5V. It is operating at 0°C~70°C TA. It belongs to the type JK Typeof flip flops. This type of FPGA is a part of the 74F series. You should not exceed 130MHzin its output frequency. As a result, it consumes 19mA quiescent current and is not affected by external forces. 16terminations have occurred. It is a member of the 74F112 family. It is powered by a voltage of 5V . In this case, the D flip flop belongs to the F/FASTfamily. There is an electronic part that is mounted in the way of Surface Mount. This board is designed with 16pins on it. It has a clock edge trigger type of Negative Edge. It is included in FF/Latches. The superior flexibility of this circuit is achieved by using 2 circuits. On the basis of its reliable performance, this D flip flop is well suited for use with TR. In order for the device to operate, it requires 5V power supplies. In order to achieve high efficiency, the supply voltage should be maintained at 5V. With an output current of 20mA, it is possible to design the device in any way you want.

SN74F112NSR Features

Tape & Reel (TR) package
74F series
16 pins
5V power supplies

SN74F112NSR Applications

There are a lot of Texas Instruments SN74F112NSR Flip Flops applications.

• QML qualified product
• Consumer
• CMOS Process
• Memory
• Cold spare funcion
• Storage Registers
• Single Down Count-Control Line
• Guaranteed simultaneous switching noise level
• ESD protection
• Latch