SN74F174ADR

SN74F174ADR Overview

As a result, it is packaged as 16-SOIC (0.154, 3.90mm Width). There is an embedded version in the package Cut Tape (CT). This output is configured with Non-Inverted. JK flip flop uses Positive Edgeas the trigger. The electronic part is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. A temperature of 0°C~70°C TAis considered to be the operating temperature. Logic flip flops of this type are classified as D-Type. The 74Fseries comprises this type of FPGA. You should not exceed 140MHzin its output frequency. A total of 1 elements are present. During its operation, it consumes 45mA quiescent energy. There are 16 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The 74F174 family contains this object. A voltage of 5V is used as the power supply for this D latch. An electronic device belonging to the family F/FASTcan be found here. This electronic part is mounted in the way of Surface Mount. The 16pins are designed into the board. There is a clock edge trigger type of Positive Edgeon this device. This RS flip flops is a part number FF/Latches. An electronic part designed with 6bits is used in this application. Using 7 circuits, it is highly flexible. As a result of its reliability, this D flip flop is ideally suited for TR. It operates from 5V power supplies. In order to ensure high efficiency, the supply voltage should remain at 5V. The output current of 20mA makes it feature maximum design flexibility. In order to operate, the chip has 6 output lines.

SN74F174ADR Features

Cut Tape (CT) package
74F series
16 pins
6 Bits
5V power supplies

SN74F174ADR Applications

There are a lot of Texas Instruments SN74F174ADR Flip Flops applications.

• Buffer registers
• Automotive
• Balanced 24 mA output drivers
• Bounce elimination switch
• Test & Measurement
• Shift Registers
• Load Control
• Registers
• Computers
• Parallel data storage