SN74F174ADRE4

SN74F174ADRE4 Overview

16-SOIC (0.154, 3.90mm Width)is the way it is packaged. As part of the package Tape & Reel (TR), it is embedded. T flip flop uses Non-Invertedas its output configuration. It is configured with the trigger Positive Edge. There is an electronic component mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. In this case, the operating temperature is 0°C~70°C TA. It belongs to the type D-Typeof flip flops. The FPGA belongs to the 74F series. It should not exceed 140MHzin terms of its output frequency. In total, it contains 1 elements. It consumes 45mA of quiescent current without being affected by external factors. 16terminations have occurred. This D latch belongs to the family of 74F174. It is powered by a voltage of 5V . A device of this type belongs to the family of F/FAST. In this case, the electronic component is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 16. This device has the clock edge trigger type of Positive Edge. It is included in FF/Latches. An electronic part designed with 6bits is used in this application. Despite its superior flexibility, it relies on 7 circuits to achieve it. In view of its reliability, this D flip flop is a good fit for TR. The D latch operates on 5V volts. If high efficiency is desired, the supply voltage should be kept at 5V. With an output current of 20mA, it is possible to design the device in any way you want. There are no output lines on the JK flip flop.

SN74F174ADRE4 Features

Tape & Reel (TR) package
74F series
16 pins
6 Bits
5V power supplies

SN74F174ADRE4 Applications

There are a lot of Texas Instruments SN74F174ADRE4 Flip Flops applications.

• Communications
• Frequency Dividers
• Digital electronics systems
• Individual Asynchronous Resets
• Single Down Count-Control Line
• Memory
• Safety Clamp
• Matched Rise and Fall
• Test & Measurement
• Bounce elimination switch