SN74F377ADWR

SN74F377ADWR Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. A package named Tape & Reel (TR)includes it. The output it is configured with uses Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis occupied by this electronic component. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. The operating temperature is 0°C~70°C TA. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74Fseries FPGA. Its output frequency should not exceed 125MHz Hz. The element count is 1 . Despite external influences, it consumes 72mAof quiescent current. It has been determined that there have been 20 terminations. JK flip flop belongs to 74F377 family. A voltage of 5V is used as the power supply for this D latch. F/FASTis the family of this D flip flop. It is mounted by the way of Surface Mount. 20pins are included in its design. A Positive Edgeclock edge trigger is used in this device. The part you are looking for is included in FF/Latches. The design is based on 8bits. The superior flexibility is achieved through the use of 8 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. There are 5V power supplies attached to it. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. The 20mA output current allows it to be designed with the greatest amount of flexibility. It is also characterized by WITH HOLD MODE.

SN74F377ADWR Features

Tape & Reel (TR) package
74F series
20 pins
8 Bits
5V power supplies

SN74F377ADWR Applications

There are a lot of Texas Instruments SN74F377ADWR Flip Flops applications.

• Control circuits
• Buffered Clock
• Supports Live Insertion
• Data transfer
• CMOS Process
• Divide a clock signal by 2 or 4
• Single Down Count-Control Line
• Memory
• Single Up Count-Control Line
• ESCC