SN74F377AN

SN74F377AN Overview

The flip flop is packaged in a case of 20-DIP (0.300, 7.62mm). The Tubepackage contains it. This output is configured with Non-Inverted. The trigger configured with it uses Positive Edge. Through Holemounts this electrical part. The JK flip flop operates at a voltage of 4.5V~5.5V. In the operating environment, the temperature is 0°C~70°C TA. This electronic flip flop is of type D-Type. JK flip flop is a part of the 74Fseries of FPGAs. Its output frequency should not exceed 125MHz Hz. The list contains 1 elements. As a result, it consumes 72mA of quiescent current without being affected by external factors. There have been 20 terminations. The object belongs to the 74F377 family. A voltage of 5V is used to power it. A device of this type belongs to the family of F/FAST. This electronic part is mounted in the way of Through Hole. The 20pins are designed into the board. A Positive Edgeclock edge trigger is used in this device. There is a base part number FF/Latchfor the RS flip flops. It is designed with 8bits. The superior flexibility of this circuit is achieved by using 8 circuits. The system runs on a power supply of 5V watts. For high efficiency, the supply voltage should be set to 5V. This T flip flop features a maximum design flexibility due to its output current of 20mA. Furthermore, it has WITH HOLD MODEas a characteristic.

SN74F377AN Features

Tube package
74F series
20 pins
8 Bits
5V power supplies

SN74F377AN Applications

There are a lot of Texas Instruments SN74F377AN Flip Flops applications.

• Control circuits
• ATE
• CMOS Process
• Shift registers
• Circuit Design
• 2 – Bit synchronous counter
• Synchronous counter
• Single Down Count-Control Line
• Data storage
• Consumer