SN74F574N

SN74F574N Overview

The item is packaged in 20-DIP (0.300, 7.62mm)cases. Package Tubeembeds it. T flip flop uses Tri-State, Non-Invertedas the output. This trigger is configured to use Positive Edge. There is an electrical part that is mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis used as the supply voltage. 0°C~70°C TAis the operating temperature. This D latch has the type D-Type. In this case, it is a type of FPGA belonging to the 74F series. This D flip flop should not have a frequency greater than 100MHz. A total of 1elements are present in it. A total of 20terminations have been recorded. JK flip flop belongs to 74F574 family. The D flip flop is powered by a voltage of 5V . The electronic device belongs to the F/FASTfamily. In this case, the electronic component is mounted in the way of Through Hole. The 20pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. 8bits are used in its design. In order to achieve its superior flexibility, 8 circuits are used. In order for the device to operate, it requires 5V power supplies. This flip flop has a total of 2ports. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. The 24mA output current allows it to be designed with the greatest amount of flexibility. There are 3 output lines on it.

SN74F574N Features

Tube package
74F series
20 pins
8 Bits
5V power supplies

SN74F574N Applications

There are a lot of Texas Instruments SN74F574N Flip Flops applications.

• Memory
• Single Up Count-Control Line
• Registers
• Buffered Clock
• Synchronous counter
• Pattern generators
• Differential Individual
• Counters
• EMI reduction circuitry
• Frequency Divider circuits