SN74F574NSR

SN74F574NSR Overview

The item is packaged in 20-SOIC (0.209, 5.30mm Width)cases. You can find it in the Tape & Reel (TR)package. As configured, the output uses Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis in the way of this electric part. A supply voltage of 4.5V~5.5V is required for operation. The operating temperature is 0°C~70°C TA. The type of this D latch is D-Type. JK flip flop belongs to the 74Fseries of FPGAs. A frequency of 100MHzshould not be exceeded by its output. In total, it contains 1 elements. A total of 20 terminations have been made. You can search similar parts based on 74F574. Power is provided by a 5V supply. An electronic device belonging to the family F/FASTcan be found here. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. This device has Positive Edgeas its clock edge trigger type. This RS flip flops is a part number FF/Latches. There are 8bits in its design. Despite its superior flexibility, it relies on 8 circuits to achieve it. As a result of its reliability, this D flip flop is ideally suited for TR. The system runs on a power supply of 5V watts. This D flip flop is equipped with 0 ports. In order to ensure high efficiency, the supply voltage should remain at 5V. Its output current of 24mAallows for maximum design flexibility. It is designed with 3 output lines. Quiescent current is consumed by the D latch in the amount of 86mA.

SN74F574NSR Features

Tape & Reel (TR) package
74F series
20 pins
8 Bits
5V power supplies

SN74F574NSR Applications

There are a lot of Texas Instruments SN74F574NSR Flip Flops applications.

• Event Detectors
• Frequency Dividers
• Data transfer
• Shift Registers
• Single Up Count-Control Line
• 2 – Bit synchronous counter
• Supports Live Insertion
• Convert a momentary switch to a toggle switch
• High Performance Logic for test systems
• Single Down Count-Control Line