SN74HC273NSRG4

SN74HC273NSRG4 Overview

In the form of SOP, it has been packaged. It is contained within the Tape & Reel (TR)package. A total of 20 terminations have been made. The power supply voltage is 5V. In this case, the D flip flop belongs to the HC/UHfamily. It is mounted in the way of Surface Mount. It is designed with 20 pins. This device has Positive Edgeas its clock edge trigger type. There is a FF/Latchesbase part number assigned to the RS flip flops. 8bits are used in its design. The superior flexibility is achieved through the use of 8 circuits. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. If high efficiency is desired, the supply voltage should be kept at 5V. There are 1 output lines in this JK flip flop. The number of input lines is 2. In addition, DUMMY VALis a characteristic of it. -5.2mA is set as the high level output current. There is no low level output current set at 5.2mA. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. The system operates with a minimum supply voltage of 2V. In this case, it supports a maximum supply voltage of 6V. 60MHzis the maximum frequency that can be achieved. This logic IC is D FLIP-FLOP. It is equipped with 1 Functions . 20pins are provided on the D latch. It features maximum design flexibility due to the 5.2mA output current.

SN74HC273NSRG4 Features

Tape & Reel (TR) package
20 pins
8 Bits
1 Functions
20 pin count

SN74HC273NSRG4 Applications

There are a lot of Texas Instruments SN74HC273NSRG4 Flip Flops applications.

• Bus hold
• Common Clocks
• Single Down Count-Control Line
• Frequency division
• CMOS Process
• ESD protection
• Latch
• Data storage
• Storage Registers
• High Performance Logic for test systems