SN74HC273QDWRG4Q1

SN74HC273QDWRG4Q1 Overview

The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). As part of the package Tape & Reel (TR), it is embedded. As configured, the output uses Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 2V~6V volts. It is at -40°C~125°C TAdegrees Celsius that the system is operating. This D latch has the type D-Type. In this case, it is a type of FPGA belonging to the Automotive, AEC-Q100, 74HC series. Its output frequency should not exceed 60MHz. In total, there are 1 elements. There is a consumption of 8μAof quiescent energy. The number of terminations is 20. D latch belongs to the 74HC273 family. A voltage of 5V is used to power it. This T flip flop has a capacitance of 3pF farads at the input. In this case, the D flip flop belongs to the HC/UHfamily. There is an electronic part mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. It has a clock edge trigger type of Positive Edge. This part is included in FF/Latches. This flip flop is designed with 8 Bits. It reaches the maximum supply voltage (Vsup) at 6V. If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 2V. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. The power supply is 2/6V. In order to achieve high efficiency, the supply voltage should be maintained at 5V. As of now, there are 8input lines.

SN74HC273QDWRG4Q1 Features

Tape & Reel (TR) package
Automotive, AEC-Q100, 74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC273QDWRG4Q1 Applications

There are a lot of Texas Instruments SN74HC273QDWRG4Q1 Flip Flops applications.

• Frequency Dividers
• ESCC
• Frequency division
• ESD performance
• Set-reset capability
• Common Clocks
• Consumer
• Latch
• Shift Registers
• Reduced system switching noise